Companion Dock installer
Puts the firmware on a Waveshare ESP32-P4-WIFI6-POE-ETH board, straight from this page.
This browser can't talk to the board. Open this page in Chrome or Edge on a computer (Windows, macOS or
Linux). Safari, Firefox and phones don't support USB serial devices.
Install
…Looking for the latest firmware
- Connect the board's USB-C port to this computer with a data cable. The USB-A port is for the Stream Decks.
- Press Connect and install and pick the board in the list. It usually shows up as "USB Single Serial", "CH343" or "usbmodem".
- Wait until it says it's done, about 3 minutes. Leave the cable in meanwhile.
This is a fresh install. It erases the box's settings: Wi-Fi networks, the settings
PIN and the Companion address. To update a box that already runs Companion Dock and keep its settings, open the
box's web page and upload the new
companion-dock-v….bin on its Firmware page instead.Use a firmware file from this computer
Pick a full image, the one whose name ends in -full.bin. It's written at address 0x0, like the latest one.
After installing
The box restarts and the Stream Decks show the setup screen with two QR codes.
- Scan the first code with your phone to join the box's hotspot.
- Scan the second to open the setup page, then join your network on its Wi-Fi page, or plug in an Ethernet cable.
- Add the box in Companion. How to add it covers both modes.
If it doesn't work
- The board isn't in the list. Try another cable (charge-only cables have no data wires) and plug straight into the computer, not through a hub. On Windows, if no COM port appears, install WCH's CH343 driver.
- It can't connect. Close anything else that has the port open, such as a serial monitor or the Arduino IDE. Then put the board in download mode by hand: hold BOOT, press and release RESET, release BOOT, and try again.
- It stopped halfway. Nothing is broken. Press RESET on the board and install again.
- The log below shows exactly what happened. It helps if you open an issue.